Planar WS231 Bedienungsanleitung

WS231

User’s Manual 5 Figure 1-4: Connecting Power to the LCD Monitor Connecting Video 1. Turn off your PC and the LCD Monitor before connecting your LCD

User’s Manual 6 Figure 1-5: Connecting the LCD Monitor to the PC 3. If your PC has a graphic card with a 24-pin DVI connector, you may connect it wi

7 CHAPTER 2 The Display Controls The LCD Monitor’s Display Controls The LCD Monitor features an intuitive, menu-driven, On-Screen Display (OSD). You

User’s Manual 8 The submenus for each are further described below: Display Setting sub Menu Figure 2-2: The Display Setting sub Menu Description: •

User’s Manual 9 Description: • SCALE Full Screen or native display selection. • CLOCK To adjust the pixel alignment of the display. • PHASE To adjust

User’s Manual 10 Color temp. Sub Menu Figure 2-5: The Color temp. Menu Description: • 9300 CIE 9300°K color. • 6500 CIE 6500°K color. • R User color

User’s Manual 11 Digital Input Mode (use 24 pin DVI port): Figure 2-6: The OSD Main Menu Main Menu Description: • DISPLAY Display Setting parameters

User’s Manual 12 Description: • CONTRAST Contrast adjustment. • BRIGHTNESS Backlight brightness adjustment. • LANGUAGE To select different languages o

User’s Manual 13 (Analog mode) (Digital mode) Figure 2-9: When there is no input signal The hotkey descriptions Figu

14 ADDENDUM A Technical Information TFT LCD Monitor Specifications Model FMT2315U LCD Panel 23.1” UXGA Control Functions Power Software switch with

User’s Manual i PREFACE FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditi

15 Model FMT2315U Scanning Frequency H/V, Hz (Digital mode) 30-80kHz 56-85 Power Management Meets VESA DPMS Power Consumption (ON mode/O

16 APPENDIX B Supported Timing Timing for Model FMT2315U (UXGA Resolution) Item Standards ResolutionDot Clock (MHz)Vertical Scanning Frequency(Hz)

17 Item Standards Resolution Dot Clock(MHz) Vertical ScanningFrequency (Hz) HorizontalScanning Frequency(kHz) Sync Polarity or composite syn

18 APPENDIX C Troubleshooting Troubleshooting Procedures This LCD Monitor was pre-adjusted in the factory with standard VGA timing. Due to output ti

19 PROBLEM: There is no LCD Display If there is no display on the LCD, please perform the following steps: 1. Make sure that the power indicator o

620050721002/04

User’s Manual ii CE mark for Class B ITE (Following European standard EN55022/1998; EN61000-3-2/1995; EN61000-3-3/1995, EN55024/1998, EN60950/1992+A1

User’s Manual iii Important Safety Instructions Please read the following instructions carefully. This manual should be retained for future use. 1.

User’s Manual iv TABLE OF CONTENTS PREFACE...

1 CHAPTER 1 The LCD Monitor Your new LCD Monitor! Your LCD Monitor has been designed to be versatile, ergonomic and user-friendly. The LCD Monitor i

User’s Manual 2 If you find that any of these items are missing or appear damaged, contact your dealer immediately. Do not throw away the packing mat

User’s Manual 3 4. Power Button and Port Select Push the button to turn the Monitor ON or OFF (push and hold the button for 2 seconds to switch betwe

User’s Manual 4 Adjusting the Viewing Angle Your LCD Monitor is designed to allow you to adjust it to a comfortable viewing angle. Please see Figure 1